Rebuilt Meyer E60H E-60H Snow Plow Pump ( New Ram & Motor & Coils!) E57H

Please read the entire description!!!! If you’re not sure which pump you need please message us and we can help you. Fully refurbished Meyer E-60H snow plow pump. THIS IS THE HIGH LIFT MODEL NOT A STANDARD LIFT E60. If you need a regular E60 please check our other listings. New seal kit. New Ram. (ball honed cylinder). New dual stud starter motor which is an upgrade to the original design. New A coil. New B coil. New C coil. New crossover seal kit and spring. New pin type couplers. New vent plug on top. New hardware kit including ground bolt, star washer and drain plug. Unit was stripped, primed, painted and new decals installed. No old broken welded bases here! Pump in the pictures is the actual pump you will receive. Tested THOROUGHLY under load on a test stand and adjusted. Works great. Some chips, scratches, runs and or flaws in the paint. Drained of oil for shipping. We recommend flushing angle rams and using a high quality low temp plow fluid such as Meyer M1 fluid. MAKE SURE YOUR PLOW SIDE HAS PIN TYPE COUPLERS. We use pin type couplers so you must use the same type on your plow itself. Pin type couplers are not compatible with ball type couplers. MISMATCHED COUPLERS WILL LEAD TO ANGLING PROBLEMS! If you need a set of pin type couplers let us know before purchasing pump.(+25 for couplers) This motor is a dual stud motor which requires an extra negative cable, if you do not have one please let us know and we will get you one. Sold as is. Thank you. Some things to remember when buying a “refurbished” or “rebuilt” pump. Avoid any pumps that only give you a vague description of what’s been done to it. (Example “any defective components replaced” know exactly what your new pump is getting) Always make sure your new pump is getting a new lift ram (any defects in a used ram will allow water in making your new pump freeze up when you need it most). I’d think twice about buying a pump that was assembled using Teflon plumbers tape to seal the joints. That stuff breaks down over time and clogs your pump up. Ask if the base has ever been broken and welded back together. I wouldn’t pay that kind of money for an old broken base that’s been bubble gum welded back together. Also make sure you’re getting new couplers, a new crossover spring and a new starter motor. Don’t put your trust in to 30 year old parts in a blizzard. Thanks for looking

• Brand: Meyer
• Part Type: Snowplow Pump