Model A Ford Zenith 2 Carburetor by Holley Raised Letters Brass 1929 Tested (H)

Selling an original Zenith 2 carburetor made by Holley of Detroit for Model A Ford cars and trucks over 90 years ago. The bowl casting has some what rare raised Zenith 2 letters. There is no "H" on the top indicating a somewhat later  1929 production, but it will run fine on all 4 years of production. It was bead blasted, passages cleaned and painted judging correct flat black gas proof paint. I then cleaned, threads and jets checked, parts replaced as needed, and float checked for leaks and set properly. I have used as many original parts as possible to keep cost down and maintain some sort of originality. It retains nice original brass throttle and choke levers, large head idle adjust needle and brass filter. After rebuild it was test run on my 1928 Tudor, nice acceleration and idle. Please look at photos closely and feel free to ask questions, only ship to USA address. Credit given for good cores. Note that use of an air filter likely will cause engine to run rich, Ford did not put these on from the factory. Note that most slow drippy leaks start at fuel inlet and weep around bowl gasket to look like carburetor leaks.

• Brand: Ford
• Choke Type: manual
• Type: zenith
• Interchange Part Number: A9510
• Manufacturer Warranty: 1 Month
• Manufacturer Part Number: 9510-B
• Features: Up Draft
• Surface Finish: japan black
• Material: Brass
• Barrel Count: one
• Country of Origin: United States