01-05 Pontiac Aztek Glove Box Compartment Hinge 2001-2005 with Nuts & Bolts

Aztek Glove Box Hinge Used in good condition. Has minor cosmetic flaws like scratches, scrapes or scuffs you would normally expect to find on a used item. Includes 5 screws and nuts to replace the rivets. A web search may yield a video for you to watch. Required Tools: Flat screwdriver Phillips screwdriver or else a 7mm socket and rachet Electric drill with a 3/16" inch bit Vise grips or else a needle nose pliers 3/8" inch wrench. Removal Instructions: Use a flat screwdriver to pry the panel off under the glove box hinge. 3 Retainer clips hold it in place. Remove 2 phillips screws along the bottom of the glove box hinge. Remove 2 phillips screws inside the glove box. Remove the small black cabin air filter access door inside the glove box. Put your fingers inside the left side of the access door opening. Yank backward to loosen the 1 retainer clip on the left side of the glove box assembly. Often times the 2 retainer clips on the right are also loosened. Skip steps 1 to 5 if you can remove the entire glove box assembly at this point. 1) Open the front passenger door. 2) Use the flat screwdriver to remove the fuse access panel. 3) 3 Retainer clips hold it in place. 4) Use both hands to grab the glove box assembly on the far right. 5) Yank backward to loosen the 2 retainer clips on the right side of the glove box assembly. Pull the entire glove box assembly out of the dashboard. Some models have a strip of masking tape behind the glove box to hold it in place. Some models have a lamp inside the glove box. Pry a black tab to disconnect the wiring harness. Hold the 'ears' of a rivet with the vise grips or needle nose pliers. Drill through the 5 rivets with your electric drill and 3/16" inch bit. The rivets may fall apart. Otherwise, twist the vise grips or pliers for removal. Remove 4+2=6 phillips screws on the glove box door. Use a flat screwdriver to pry 2 tabs on the glove box door to remove the rectangular portion. Installation Instructions: Install the 4+2=6 phillips screws on the glove box door. Install the 5 replacement phillips screws and nuts where the rivets were. For some models reconnect the glove box lamp wiring harness. Align the 3 retainer clips and push the glove box assembly firmly into place. Align the 3 retainer clips and push the fuse access panel into place. Install the small black cabin air filter access door inside the glove box. Install 2 phillips screws inside the glove box. Install 2 phillips screws along the bottom of the glove box hinge. Align the 3 retainer clips and push the panel under the glove box hinge into place. * * * ► Item Condition: Used in good condition with minor cosmetic flaws.► Warranty: 30 Days► Pontiac Cat.

• Country/Region of Manufacture: United States
• Interchange Part Number: 10423098
• Color: Black
• Manufacturer Part Number: 10423098
• Brand: Pontiac